"Get Bent" Stubby Angled Foregrip by FFFTech/FFFTechnology A stubby, angled foregrip. Comes in two versions: Textured & Standard. To be clear: This is NOT a VERTICAL foregrip, I designed it to have a distinct grip angle of 65.4°; not like a vertical foregrip of 90°. This IS an ANGLED foregrip. Angled foregrips as of 2021, still can be attached to pistols legally. Vertical foregrips cannot. Again... it's an ANGLED FOREGRIP, as in NOT VERTICAL. Printer Used: Monoprice Maker Select Plus Filament Used: PLA+ Print Settings: Extruder: 204C Bed: 56C First Layer Print Height: .20mm Standard Layer Height: .14mm Wall Thickness: .40 Wall Perimeters: 3 - 4 Infill: 20% Infill Pattern: Gyroid Material Flow: 100% Support Material Percentage: 18% Print upside-down, using support material only for the rail slot. Hardware Needed: 1x M5x30 Hex Socketed Machine Screw/Bolt 1x M5 Hex Nut (Be sure both bolt & nut are the same thread pitch.) Installation: 1) Press the M5 hex nut into it's indexing socket. 2) With the hex nut installed, slide the forgrip onto the rail and align the bolt channel with the preferred rail slot of installation. 3) Drive the bolt through the channel and start threading into the hex nut. 4) Tighten the bolt into the hex nut until the foregrip is mounted firmly in place. The end of bolt shouldn't protrude past the hex nut indexing slot. Avoid overtightening the bolt.