Snub Guard Grip V1.3.1: FFFTech/FFFTechnology A grip set for the Smith & Wesson M & P Bodyguard 38 revolver. 4mm longer than the OEM grips, allowing for one to get their last finger on the grip. Has a slight palm swell, and is slightly thicker than the original grip. Comes in two variants: *Standard *Ridged Update V1.3.1: Thickened the inner walls .2mm on each side, (.4mm total thickness) raised the bottom inner facet by 1mm, and decreased grip retaining pin hole diameter from 1.885mm to 1.725mm. Changed recommended print settings for the commonly used Ender 3 3D printers. Printer Used: Ender 3 V2 Filament Used: PLA+ Print Settings: Extruder: 218C Bed: 56C First Layer Print Height: .20mm Standard Layer Height: .16mm Wall Thickness: .40 Wall Perimeters: 4+ Infill: 30%+ Infill Pattern: Gyroid Note: The top-rear of the grip is not as rounded as the bottom. For a more comfortable feel, sand the rear edges round before installing.