Stubby Foregrip by FFFTech/FFFTechnology

A basic stubby foregrip that attaches to a 5+ slotted section of picatinny rail. Two versions 
of the design are available; Standard (Smooth Grip) & Rib'd (Fo yo pleasure, baby)

Remember, it may be a stubby, but it has so much potential. :P
(Insert cringe here.)


Printer Used: Monoprice Maker Select Plus

Filament Used: PLA+

Print Settings:

Extruder: 204C 
Bed: 56C 
First Layer Print Height: .20mm 
Standard Layer Height: .14mm
Wall Thickness: .40 
Wall Perimeters: 3 - 4
Infill: 20%
Infill Pattern: Gyroid
Material Flow: 100%

Print from the bottom of the grip, no support material is needed.


Hardware Needed: 

1x M5x30 Hex Socketed Machine Screw/Bolt

1x M5 Hex Nut (Be sure both bolt & nut are the same thread pitch.)


Installation:

1) Press the M5 hex nut into it's indexing socket.

2) With the hex nut installed, slide the forgrip onto the rail and align the bolt channel with
   the preferred rail slot of installation.

3) Drive the bolt through the channel and start threading into the hex nut.

4) Tighten the bolt into the hex nut until the foregrip is mounted firmly in place. The end of 
   bolt shouldn't protrude past the hex nut indexing slot. Avoid overtightening the bolt.