"Between the Ribs" Push Dagger: FFFTech/FFFTechnology

An offset T-handle push dagger with a double edged blade. One side transitions from a straight 
edge, then slopes forwards towards the tip. The other side is a straight blade with a wide tanto 
styled tip. 

This slender design is suited for reaching organs between and under the rib cage. 


Printer Used: Ender 3 V2

Filament Used: PLA+

Print Settings:

Extruder: 218C 
Bed: 56C 
First Layer Print Height: .18mm 
Standard Layer Height: .12mm
Wall Thickness: .40 
Wall Perimeters: 8+
Infill: 50%+
Infill Pattern: Gyroid
Material Flow: 100%


Note: Due to this specific push dagger's slim design, it's HIGHLY recommended to print with at LEAST 
8+ walls for best durability within it's intended design parameters.