------https://kimballgoss.wixsite.com/altivoloengineering------ ------ALTIVOLO ENGINEERING CMMG 22LR MAG REMIX----- Thanks for downloading, hope you enjoy your sick new 22LR mag! But first we got to get some things in order. NOTE: This design is a work in progress. Please be careful and treat this magazine as "experiemental" If you have any issues, run into any blocks, or you have any suggestions, I'd love to hear it, please email me at AltivoloEngineering@gmail.com -----------------PRINT SETTINGS:-------------------- SEE PRINT ORIENTATION PICTURES Material: PLA or PLA+ (I suggest PLA+) Temperature: 215C Buildplate: 60C Wall Line Count: 2 Top Layers: 4 Bottom Layers: 4 Infill Density: %20 (could be higher if you want) Supports: YES (%20 density, higher if you print slower/hotter) Build Plate Adhesion: I would suggest a brim of 8mm, especially for the follower file -------------------POST PRINT:----------------------- 1. Remove all brims and supports, and see BOM.txt for you parts list. 2. Tap the holes on the Right Side Mag with M3 thread. These holes self thread if you just start screwing in an M3 screw. 3. Using six M3x14mm screws, line up the right and left sides, and screw the two halfs together tightly, but don't strip the threading on your right mag half. The screw heads should be flush with the left side mag face. 4. Insert the follower in the bottom of the mag, and ensure that it travels smoothly up and down the path. 5. place the spring over the follwer and insert it into the mag. 6. Have your four M3x6mm screws ready, push the cap onto the bottom of the mag, compressing the spring and making sure your not damaging/bending the spring. 7. Once the bottom cap is flush, you can temporarily tape it in place, or just start screwing your four M3x6mm screws into place. 8. Slide you mag in and out of your AR lower, make sure it works to your liking. (I had to shave down some corners to make mine slide in and out easier) 9. Load some 22lr ammo into your mag and ensure you can load 25 rounds, and that they feed/release correctly. 10. Enjoy!