Printable AR-15 Case Deflector
	Designed for use on T-91 uppers, should work fine on anything with a pic rail. Some fitment may been needed for things that aren't a T-91 upper.


Printed Parts Checklist:	
	Deflector Body
	Deflector Clamp

Hardware Checklist:
	Refer to the "Shopping List" section of the build tutorial pdf.


General Print Settings:
My print settings for PLA+ were as follows:

	Walls: 8 (Very important to set walls to 8 - you should be able to go higher, but going lower will signifcantly weaken the flanges that mate the receiver sections)
	Nozzle: 0.4mm
	Layer Height: 0.15mm
	Temp: 230/60C
	Infill: 100%
	Supports: On/full (tree supports are ok)
	Cooling fan: 20% normal, 50% on bridges. Or whatever works for you. It's a simple part.
	Bed Adhesion: gluestick or hairspray - since the big sections of this print have small footprints on the bed, using plenty of gluestick or hairspray is recommended.

	All other settings can/should be left as default or whatever you know works best with your printing setup.