****Semi-printed .223 Suppressor****
										Designer: iprintgunz


							---"Official" Safety Rating: .22LR Rapid-Fire and .223 Slow-Fire---



_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____
*******************************************************************************************************************************************************************************************
********************This item is a suppressor/silencer. To legally own this, you must complete an ATF Form 1. I cannot FORCE you to file the correct paperwork, however******************** 
********************you must do so if you want to keep your dog alive. The purpose of this information is not to condone/promote illegal actions, but to educate people********************
********************on how to create a suppressor. That said: all gun laws are infringements, the NFA is unconstitutional, and You Can't Stop The Signal. Deal with it.********************
*******************************************************************************************************************************************************************************************
___________________________________________________________________________________________________________________________________________________________________________________________
WARNING[1]: Do not throw this your 3-pin lower and go rambo and expect it to live. It will survive .223 rounds to an extent, 
	    but RAPID-FIRE IS NOT SUSTAINABLE (you risk severe baffle damage). Use this at your own risk.

WARNING[2]: DO NOT TRY TO DO THIS WITHOUT ANNEALING YOUR PIECES. THEY WILL MELT IMMEDIATELY. Annealing raises PLA's softening point from ~140F (60C) to ~320F (160C).

WARNING[3]: Read through the entire ReadMe and Assembly Guide before building.
___________________________________________________________________________________________________________________________________________________________________________________________
COMPONENTS:

-Apogee 8.5" D Cell Carbon Steel Tube
-1 SDTA Carbon Steel 1/2-28 Endcap
-1 SDTA Carbon Steel Blank Endcap
-6x printed mid-baffles
-1x printed blast-baffle
-1x printed blast chamber
___________________________________________________________________________________________________________________________________________________________________________________________
Print Information:

-Hatchbox PLA (black)
-0.2mm layer height
-0.4mm nozzle (most printers use this standard)
-100% perimeters/walls, you shouldn't need any normal infill
-Whatever temperature PLA prints best on your printer
-No supports
-Cone-up orientation
___________________________________________________________________________________________________________________________________________________________________________________________
Note: You can print the endcap tool however you want, just use some reliable PLA or something.