****The Saturn Suppressor System - A 3D printable .22LR Silencer****
										Designer: iprintgunz


							---"Official" Safety Rating: Limited .22LR Rapid-Fire w/ washer reinforcement---


_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____IMPORTANT_____
*******************************************************************************************************************************************************************************************
********************This item is a suppressor/silencer. To legally own this in the USA, you must complete an ATF Form 1. I cannot FORCE you to file the correct paperwork, ****************
********************however you must do so if you want to keep your dog alive. The purpose of this information is not to condone/promote illegal actions, but to educate people************
********************on how to 3D print/design a suppressor. That said: all gun laws are infringements, the NFA is unconstitutional, and You Can't Stop The Signal. Deal with it.***********
*******************************************************************************************************************************************************************************************
___________________________________________________________________________________________________________________________________________________________________________________________

							WARNING: Read through the entire ReadMe and Assembly Guide before printing.
___________________________________________________________________________________________________________________________________________________________________________________________
COMPONENTS:

Saturn 1:
	Printed S3-1
	Optional 1/4" x 1-1/4" fender washer

Saturn 2:
	Printed S3-2 Tube
	Printed S3-2 Endcap
	Optional 1/4" x 1-1/4" fender washer
___________________________________________________________________________________________________________________________________________________________________________________________
Print Information:

-PETG (recommended), PLA+ (minimum), or any high-temp filament (best)
-0.15mm layer height
-0.4mm nozzle (most printers use this standard)
-4 perimeters/walls
-100% infill
-No supports
-Threads-up orientation for tubes
-Big-threads-up orientation for endcap
___________________________________________________________________________________________________________________________________________________________________________________________