Laffs M-Lok Slot Covers: Laffs Dynamics

Basic bitch M-Lok slot covers, tapered and rounded for comfort in the hand. 

Comes in three variants: 

 *3 Slot
 *2 Slot
 *1 Slot



Printer Used: Ender 3 V2

Filament Used: PLA+

Print Settings:

Extruder: 218C 
Bed: 56C 
First Layer Print Height: .20mm 
Standard Layer Height: .16mm - .20mm
Wall Thickness: .40mm
Wall Perimeters: 4+
Infill: 25%
Support Material Percentage: 18%

Print the AFG upside down.

Use support blockers; as the inside of the foregrip is semi-hollow. 



Hardware Needed: 

2x M5x10 Hex Socketed Machine Screw/Bolt

2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)

(Only one of each hardware part needed for the single slot cover.)