3FTech Gripstop by FFFTech/FFFTechnology

Is it a undersized foregrip? Is it an oversized handstop? I don't know to be honest, so I'm
just gonna say it's both! The foregrip/handstop/wHat has ridging down it's front to allow the
support hand to rest against/grip the design with greater traction than say, if it was smooth.

Printer Used: Monoprice Maker Select Plus

Filament Used: PLA+

Print Settings:

Extruder: 210C 
Bed: 56C 
First Layer Print Height: .20mm 
Standard Layer Height: .14mm
Wall Thickness: .40mm
Wall Perimeters: 4 -5
Infill: 25%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 30%


Print the Gripstop upside-down.


Hardware Needed: 

2x M5x10 Hex Socketed Machine Screw/Bolt

2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)