South Slav Buttstock (Yugo M70 AK): FFFTech/FFFTechnology

A hybrid design; the simplicity of a sliding wire buttstock, without the dogshit cheekweld that comes 
with them. Collapses down to 177mm/6.9in in length. 

To extend the buttstock, simply pull back until the locking bar indexes with the corresponding notches 
in the 6mm rods. Vice versa, press the locking bar actuator in, and press forwards on the butt. 



Printer Used: Ender 3 V2

Filament Used: PLA+

Print Settings:

Extruder: 220C 
Bed: 56C 
First Layer Print Height: .20mm 
Standard Layer Height: .16mm
Wall Thickness: .40 
Wall Perimeters: 5+
Infill: 32%+
Material Flow: 100%
Support Material Percentage: 16%

Print Orientations:

 *Buttstock: Buttpad, down. 

 *Stock Mount: Widest, flattest facet, down.

 *Locking Mech Mount: Front, non-angled facet down; Laffs logo upwards.

 *Locking Actuator: Upside-down, stem facing up.

 *Locking Bar: Bottom down. 

 *Notch Cutting Template: Flattest facet, down. 



Hardware Needed:

1x M8x30 Bolt, 1mm fine thread pitch (NOT 1.25mm)

1x M8 Washer, 15mm OD (Optional)

2x M4x30mm Bolts

2x M4x12mm (Or M4x15mm) Bolts

2x M4 Nuts

1x Compression Spring 3/8in x 3/4in

2x 6mm x 250mm Steel Rod



Adhesive Used: 2 Part Epoxy



(See ASSEMBLY.txt for fabrication and installation)



Accreditations:

Daikon & Doge: Used the same simple locking mechanism as the "Daikon x Dogenado MP5A3 Sliding Brace".