Black Lotus 03 Project Frame Remixes

	Original model developed by FMDA

For help completing your build, refer to 'DD17.2 Build Tutorial' pdf found in this folder. You can also watch (and download) the complete build here:
https://lbry.tv/@Ivan's_CAD_Streams:c/FMDADD17.2GlockFrameTutorial:e

For general print settings it is recommended you use settings similar to these:

*Orientation is hotly debated, however many people prefer magwell down, and rails down. some even print at a 45° angle. Find what works best for you!

*Scaling is correct.

Most common 2A related prints, especially frames and recievers, are printed in PLA+. Here is a good example of settings used for PLA+. - Note that not all PLA+ is the same. Once again, find what works best depending on the filament you are planning to use. -

We personally recommend VO3D and PolyMax Filament. They're easy to print, and have good results.

Nozzle: 0.4mm
Layer Height: 0.15mm
Temp: 230/60C
Infill: 100% (You can use 99% infill on Cura to speed up the print time)
Supports: On/full (tree supports are ok) - use a close support interface gap. Your interface gap should not be larger than 0.15mm unless you know what you are doing with your setup.
Cooling fan: 20% normal, 50% on bridges. Off for the first 10 layers. Keep the fan low to prevent warp.
Bed Adhesion: gluestick or hairspray or both



	Find updates, news, and more with these links:

https://matrix.to/#/!XXfYqhlxKdWbSZFbXC:matrix.org?via=matrix.org

https://twitter.com/ModeratorGage?s=09

https://m.facebook.com/BlackLotusCoalition/

https://mewe.com/join/biglooresearchanddevelopment

https://discord.gg/u6j95pjrfX



	If you wish to donate, these are the links:

https://cash.app/$BigIglooRD

https://www.paypal.me/gageandkatie

https://venmo.com/code?user_id=3348354599747584155&created=1630170591

https://www.subscribestar.com/blacklotuscoalition