BETA THESE FILES ARE UNTESTED

MEGA GLOCK 19X by Chairmanwon

The only changes that you need to make vs the normal FMDA profile are as follows

Support X/Y Distance: 1mm (stops Cura from supporting stipples)
Use tree supports instead of normal supports

I have tested this frame using ESUN PLA+ using the settings in the FMDA README file which I have pasted below in case this zip gets shared on its own.

Nozzle: 0.4mm
Layer Height: 0.16mm
Temp: 225-230/60C
Infill: 100%
Supports: On/full - use a close support interface gap. Your interface gap should not be larger than 0.15mm unless you know what you are doing with your setup.
Cooling fan: 20% normal, 50% on bridges. Off for the first 10 layers. Keep the fan low to prevent warp.

All other settings can/should be left as default or whatever you know works best with your printing setup.