The Glocknofsky Designed by iprintshit and Nofsky Industries

All of my glocknofsky frames were printed in esun pla+ and polymaker polymax pla on the Anycubic Vyper
	
	Print settings as follows:
		-Nozzle: 0.4mm
		-Layer Height: 0.2mm
		-Temp: 230/60C
		-Infill: 100% (You can use 99% infill on Cura to speed up the print time)
		-Supports: On/full (tree supports are ok) - use a close support interface gap. Your interface gap should not be larger than 0.15mm unless you know what you are doing with your setup.
		-Cooling fan: 20% normal, 50% on bridges. Off for the first 10 layers. Keep the fan low to prevent warp.
		-Bed Adhesion: PEI sheet!!
		-Post Processing: Printed rails down so clean the inside and rock n roll!

		All other settings can/should be left as default or whatever you know works best with your printing setup.