Nadda Spuhr Stock
v2.0

	The Nadda Spuhr Stock is a 3D printable Spuhr-style stock for CETME C rifles.
	Also included is the NotaStawk - a brace version of the Spuhr, perfect for your HK51-esque builds. Credit to defualtt for the design of the brace!

Printed Parts Checklist:

	Stock x1
	Lock Block x2
	Adjust Lever x2
	Mount/Cheekrest x1
		Two versions are avaliable - AG, which is specific to the Amigo Grande and matches the profile of the Grande's rear receiver,
		and a Generic version, which will work with standard CETME C builds (and still works with the Amigo Grande, it just won't match the profile). 
	(Optional) SphurMod Rear Receiver - an alternate to the Amigo Grande's rear receiver section, which matches the profile of the Sphur stock's cheekrest and allows the shooter to "choke up" on the stock.

Hardware Checklist:
	
	Adjust Lever Springs - Pen Springs can be modified to work, these springs are recommended: https://www.mcmaster.com/9434K25/
	(Optional) 15-17mm long, 2mm diameter roll pin x4 - can replace the use of filament pins.


**Note that all STL files are oriented and scaled properly, and changing their scale or orientation may result in your parts not fitting/working properly.**

Print at 8 walls/top/bottom layers, 25% infill is sufficent. PLA+ is tested as working well.


Some fitting may be needed for the locking blocks - use a boxcutter to remove any deformation where the part was touching the print bed, use sandpaper or a Dremel tool if the block fits too tight.
Using some grease on the lock blocks is fine, and can help things fit better.


Refer to the Tutorial PDF for help in assembling your stock!